No green led and no connection
  • Hello;

    I was using basecam electronics board successfuly but now i cant. When i connect the usb, only red led is ligthing and green led is not working. When i try to connect via GUI, it couldnot connect to the board. Furhtermore when i try to flash firmware via AvrDude i get the following message :

    stk500_getsync(): not in sync: resp=0x00

    I am not an expert but as far as i research, it is generally steamed from bootloader problem. So, what could i do ??
  • Hi,

    I can´t help, but I´m in the same situation, but with the board of this gimbal


    The board version is the 2.03b of simplebgc (http://www.simplebgc.com/eng/downloads/)

    I was updating it, something went wrong and after removing the usb, then I´m in the same situation as you are. I think it´s a bootloader problem.
  • rhrueda, on your link is not simpleBGC controller, rather fake board.