EN CN
Control Pitch & Yaw on alexmos board
  • jonathan311
    Hi everyone,

    I would like control those 2 axis on my alexmos board v2.3b5 firmware. I'm using
    a 3S battery.

    When I plug a servo tester or a 3 channel receiver on RC_Pitch, RC_Roll, FC_pitch & FC_Roll,
    it seems there is no power on those pins, like if there were not activate.

    In the RC control of the software, I select RC_Pitch analog when I plug the servo tester
    and PWM when I plug the receiver.

    But nothing happen.

    Someone have an idea how activate this option?

    Thank a lot.

    Jonathan
  • Tasz
    solder jumper L1
  • jonathan311
    Sorry but can you give me more details please?

    Thanks a lot
  • NYANA_Myanmar
    I got same issue, thanks Tasz!, I figure it out.Now ok.
    Dear Jonathan311 , there is 2 spot near sensor pin on the main board wrote L1 , just solder it.
Add a Comment