EN CN
Hello and how much does cogging matter?
-
Hi all,
First time I've been one of the first on a forum, here's hoping it all goes well here.
Per title, how much does the cogging affect the gimbal?
D -
Hello, maddog! you are welcome!
Big cogging is not good for gimbal, because main principle of this kind of stabilization - use inertia of a camera while mechanically unbind camera from the main frame. Cogging will tie camera to frame.
So, you should choose motors with minimal cogging effect. If you able to turn motor holding its shaft by fingers and not applying to much force, cogging is good. -
I would like to build your board when will we see a more detailed schematic. Can you send something through to help me get started?
-
Schematics pretty simple but it will not work without firmare. Unfortunatelly firmware is not open source and will not work outside "oficcial" boards from my partners.
-
Thanks Alex.
I think I've found a couple of motors to try with!
Cheers
D
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!