EN CN
Yaw motors aims camera backwards
  • gtranquilla
    Camera points backwards when powered up and remains there until I take RC remote control..... Red dot in the compass needle dynamic graphic continuously rotates clockwise..... The frame IMU is mounted upside down between yaw motor and roll motor.
    Is this a firmware bug?

    I AM SO TIRED FIGHTING WITH THIS BGC.......

    32bit - 3axis large board with 2.41 b4 firmware.
  • 200sx
    Did you check that your yaw motor connection is inverted? Try check/uncheck the box for invert in the basic>motor configuration>yaw.
  • gtranquilla
    Resolved once I recalibrated frame IMU gyros.
  • zsntiancai
    I have the same problem,
    Gyros recalibrated is effective, but,
    when I write a new parameter, camera points backwards in sometimes.
Add a Comment