Hi, everybody.
I have an issue with the horizont level on my 8 bit alexmos board (firmware 2.4b7) with 3rd extention board.
In follow mode YAW+Pitch+Roll i've checked "estimate frame angles from motors" and did an auto OFFSET adjustment and the horizont is fine, everything works perfectly!!!
But, after i switch to No Follow Mode or Follow Yaw Only the gimbal change its horizont by about -5 degrees to the left (exactly the same angle for both)...
Note that i have unchecked "estimate frame angles from motors" in No Follow Mode and have checked "estimate frame angles from motors" for Follow Yaw Only and for Follow Yaw+Pitch+Roll... I even tried to check "estimate frame angles from motors" for No Follow Mode, but same result, horizont changes to - 5 degrees (to the left) after switching from Follow Pitch+Roll+Yaw to No Follow Mode or Follow Yaw only...
I don't have a joystick to adjust the horizont as Alex is doing in his video.

Any help will be appreciated!