Could some one tell me what the wiring between the NAZA receiver and the pins on the DYS 3 axis gimbal for manual control of the pitch? I know that the outputs from the NAZA are on port f2 but would like the wiring diagram for the DYS. Cheers. Vlad.
You can use a standard servo cable. GND black, +5V red and signal white. (DJI of course is using different colours GND brown, +5V red and signal orange.)
For any gimbal it is good to remove the + 5 V wire (the middle wire), it is not needed as both units already get power and for this reason it could actually break something, so remove the + wire.