EN CN
Power is not set
  • sammaleg
    Hello,

    I have finally managed to connect the controller to my mac (10.6.8). Upgraded the firmware to 2.40 b7 (had to borrow a Windows machine).

    I would like to start to adjust the controller setting but it says "Power is not set". In fact it is set. I tried 50, 100, 200 and click "write" and still no change. Motors will not respond and I get the same message.

    Can you help?

    M.
  • sammaleg
    So it seems to come and go. I have disabled the 3rd axis extended board. So far so good.

    Except now the sensor won't keep level. It seems to get stuck a little right on the roll axis.

    I also cannot explain why the compass in GUI never stays still. The blue arrow is constantly rotating clockwise.
Add a Comment