EN CN
Controlling roll from RC channel
-
Hi!
I have a 2-axis gimbal working fine in all aspects except for the ability to control roll axis from the RC_ROLL input on my ArmBGC v3.0 board. It is set to PWM mode for both roll and tilt and tilt is working just fine. If I activate the swap of roll and tilt I can control the roll. It seems to be some problem with the RC_ROLL input. I have of course tested the connected channel with a servo. Has anyone else experienced the same thing? Is there anyone successfully controlling both roll and tilt with a ArmBGC v3.0 board?
Many thanks in advance for any hit or help with this! -
What does the Realtime Data show for RC_ROLL when you use it?
If you map (RC Input Mapping) your current and working tilt channel to Roll, is it then controlling Roll?
-
Hi Garug!
The real time data shows nothing for my roll channel RC input changes. Absolutely dead.
If I map my tilt channel to the roll I can adjust the roll. -
Then I think your RC_ROLL input must be dead.
-
Yes, that is what I also suspect.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!