EN CN
No LED blinking on board and gimball going "crazy"
  • Istrijan
    Hi,
    i'm writing here because I have a very huge problem with my ARRIS CM2000.
    Everything works fine until yesterday.

    Now every time i start my Phantom the gimball starts oscillating without any control, and now is unusable.

    I try to connect it to Simple BGC with a mini USB cable, but the software says that the GUI doesn't match the board. What can I do now to repair this problem?
    I also noticed that no LED is blinking on the board.


    I took a video of the problem:



    Thanks in advance for helping me...

    P.S. Sorry for my bad english...i'm from Croatia!


    Have a nice day
  • cata
    1st of all try to update the firmware with one of the two options of software from the downloads tab (http://www.basecamelectronics.com/downloads/).

    After you are done with the firmware update the GUI will recognize the board and you are ready to set it up.
  • pau1
    Does it say the firmware is version 0.53b?
  • AirgunBrasil
    I have the same problem, but when I try to update I got a fail. Out of sync.
    When I turn it on, after few seconds the gimbal shake and turn all directions and motor make a thin noise like a tiiiiiiiiiiiiiiiiiiiiii..
    I try update using everthing.
Add a Comment