EN CN
USB PC NOT POWERING
  • supertabouret
    Hello,

    When I plug the usb pc cable the board won't start (no light nothing)
    When I put the connect the lipo the board starts fine(all led show no material errors) then I load the gui 1.3 and it connects com4 fine then click read and nothing shows not values.
    When I try upload firmware with xload, it says upload failed nothing is written.

    So I can't upload firmware, i can't read write.
    Any idea?
    Is the board broken? Any Safe mode?

    Hope you faced that problem already..
    Hope you can help,
    Thank you..
  • Garug
    Sounds like broken board, at least USB. You could try the serial port, maybe via Bluetooth.
Add a Comment