EN CN
small jitter from RC input
  • simon
    Hi!
    I have a problem with small movement/jitter when I try to control pitch axis with RC. I cannot remove it satisfactory with LPF filter - when I set it to 16 there is practically no control at all:/ Probably the fluctuations are too slow.
    I tried PPM and PWM, different channels etc. It was working without problems on 2.0 firmware (if i recall correctly).

    simon
  • rsmith5413
    I'm having the same problem if you every find a solution... thanks... same here...
    it worked fine just connected to the gui... it was when I connected it up to the pwm
    line on the uav that it causes the problem...
  • rsmith5413
    the problem being... when connected to the PWM line on the uav it pivot up and down slightly constantly in the pitch axis... would not sit still...
    connected to the gui only... no problem...
Add a Comment