EN RU CN
GUI not seeing full dial throw
  • Hi, I am running 2.2b2 8 bit for an old second hand board I got (0.54 fw, unable to upgrade - copy board?)
    Anyway, its all set up and working lovely, but in manual control for pitch there is only movement for about 20 degrees of the dial turn. This shows in real time data too. Naza software and TX can see the full throw of the dial. Obviously this is very hard to fine tune, as I require around 70 degrees of movement, and to control that easily with such a small portion of a turn is impossible.
    Any tips would be appreciated - cheers!