BaseCamBGC Pro - Wiring diagram?

bit

http://oi64.tinypic.com/rwi8th.jpg

Can someone point me in direction of connecting the brushless motors (red, black, white) cables.

I can't find any information what is the (signal, + -) inputs. It just says yaw, pitch, roll as in the picture.

If anyone have any connection diagram for BaseCamBGC Pro board, let me know.

Best regards

AOPEN3434

you see where it says yaw pich roll that is the spot!

bit

Yes I know that, but in what order does it connect to the brushless motor?

bit

http://oi64.tinypic.com/2gwaz4x.jpg

Red, Black, White? Or in what order, because it does not say or does it not matter? Also does it exist any wiring diagram for the power board pro version?

AOPEN3434

there is lots of documentation on how a motor works the basics !

AndrewSupport

Hello,
Dear customer, bit
Brushless motors has three wires (connected to three phases inside) and connection method does not matter.
Likely, on your photo motors with built-in I2c_drv module.
Could you place link to the same motor here?

bit

Hi @Andrew:

I have two motors that I will try to drive, the first motor is a gimbal GB120 (PWM) and the other is a servo motor (PMW) with external power supply from teknic.

The idea is that gimbal motor should control tilt and clearpath servo should control pan movements.

First motor: Motor : GB120 gimbal motor with AS5048a (working current: 4-5A, 42P; resistance 3-4 ohms) http://brushlessgimbal.ca/BRUSHLESS-GIMBAL-PTZ/Gimbal-Brushless-Motor/3-PM10025-Brushless-Gimbal-Motor-AS5048A-BGC-Encoder-Built-In

Second Motor: https://www.teknic.com/model-info/CPM-MCVC-3432S-RLS/

I wonder how to connect these without mistakes and hope you can help. Pan movements should be able to move with joystick so any input here would also be good.

Best Regards

Howdy, Stranger!

Categories