EN CN
Pitch works like it should, ROLL is MESSED UP!
  • Ruszek83
    Hello. As stated above, Roll is jittering like hell, it is totally out of controll

    See video here:


    I have tried 1000 different gain setting, swiched motors to see if it was motor failure, still nothing. please help !

    Michael
  • thomaseichhorn
    I had the same problem with version 2 until I connected my RC receiver and switcht on the
    RC transmitter. Now everything works fine.
    Hope I could help you
  • rcjarvis
    When unplugged, is your gombal perfectly balanced ?... It has to be. The principle on brushless gimbal is only to tabilise, not to over power... so perfcet balance is necessary prior to power on !

    Dan
  • rcjarvis
    Also, your IMU should be direct to frame, this thick foam could cause echo effect... I put mine in shrink tubing to protect electronics from grounfing to aluminum frame, and then used thin double sided tape. I also placed it under the camera... Hope this helps !

    Dan
Add a Comment