EN RU CN
Problem after restarting, if signal is presented on Aux1
  • Hi. I have SBUS receiver set up on the Aux1 port. When I do restart the system (by long pressing the menu button or other methods) the controller starts tweeting (making sounds like a bird does) if the SBUS receiver is connected at the time of the restart. If not connected, no problem, but when I have anything connected to AUX1 while restarting, it tweets and the led blinks.

    The board is SimpleBGC 32-bit.

    Best regards,
    Roman
  • Hello,
    What firmware are you using? Did you try to use latest stable 2.63b0 firmware?