EN CN
Roll and Pitch home position does not work
-
Setup:
Firmware ver.: 2.63 b0, board ver.:3,6
Three motors with encoders
After everything is calibrated I set a non - zero home position for pitch and roll in "Follow" tab, but after I call "Home position" command only Yaw motor responds and roll and pitch motors are set at zero position. Even at the startup when I check all three check-boxes in a "Startup behavior" section of a "Services" tab (Search and move motors to home position at startup) only yaw motors goes home.
What might be a problem here, or basecam controller actually cant point roll and pitch axes to home position?
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!