EN RU CN
Roll and Pitch home position does not work
  • Setup:
    Firmware ver.: 2.63 b0, board ver.:3,6
    Three motors with encoders

    After everything is calibrated I set a non - zero home position for pitch and roll in "Follow" tab, but after I call "Home position" command only Yaw motor responds and roll and pitch motors are set at zero position. Even at the startup when I check all three check-boxes in a "Startup behavior" section of a "Services" tab (Search and move motors to home position at startup) only yaw motors goes home.

    What might be a problem here, or basecam controller actually cant point roll and pitch axes to home position?