EN CN
Newbie: Motor not working at all - Missing Steps
  • vincenti
    Hi,

    Just connect AlexMos Simple BGC 32 bit + 2 IMU (FW 2.6) connected with 3 Quanum DYS MT5208 360KV and having a big headache.

    The motor give a short response on start, sometime on cold start on motor will rotate just a bit only. Through GUI I got missing steps errors.

    Also tried the motor output on oscilloscope and PWM signals with amplitude around 10V are visible. I feel somehow controller and motors not talking each other properly.

    Any help appreciated!

    Thanks,

Add a Comment