EN CN
ICM20608 IMU - Sensor is not connected
  • sidg105
    hello guys,
    We bought ICM20608 IMU and, connect it to the Basecam SimpleBGC 32bit board. When we connect to GUI, we see "Sensor is not connected" error. all connection and power was checked. we use MPU-6050 before and it was OK. Can you help me, please?
    Thanks you.
  • wlliamchen
    I have the same issue， it may cause by ICM20608 I2C bus.
    solution is simple, reduce the pull-up resistor from 3.3K to 2.4K or 1.8K.
    Or simply make some gap between SCL and SDA like twist SCL with GND cable and SDA with VCC
    hope this could help : )
Add a Comment