Hello! I have a 3-axis gimbal with AlexMos 32 bit plate. Yesterday it suddenly stopped working and started to squeak. After restart, it works for a few seconds and the same thing starts. Actually pitch is working, but other two axis just doing nothing. Here is video: What could that noise mean? It appears from a pitch motor.
Hello, Did you try connect the gimbal to the GUI and check the errors at the moment when it produces extraneous sounds? If the GUI will display errors, make a screenshot and attach here.
AndrewSupport, thanks for advice, but the problem has been already solved. It was because of bad battery - voltage was too low. Works well with new battery!