EN RU CN
using "AMT203 encoder" for 3 axis insertially stabilised platform(ISP) setup.
  • hey,
    how should i connect three AMT203 encoders which use SPI protocol for communication to BaseCamBGC pro controller.

    MY ISP(gimbal setup) needs three axis stabilization. so I'm using one encoder for each axis , the encoder uses SPI protocol so each encoder has CLK , MOSI, MISO, SS, +5v, GND .

    the encoder manual from BaseCam electronics has a circuit diagram, which has some pins named CS_R, CS_P, CS_Y can you elaborate what these pins are.

    THANK YOU
  • thanks

    i get it now , CS stands for Chip Select same as Slave Select , so are the encoders connected in independent slave config as they have seperate slave select pins.