EN CN
Pitch jerking back and forth
  • rsmith5413
    the issue here is... when gimbal is connected up to the GUI, the axis's all work properly... no movements or jerking...
    BUT! when I disconnect the GUI and connect up the PWM ( pitch only ), the pitch works, but jerky up and down movements...
    this is continuous even when moving pitch up and down... this is an 8 bit board - 2 axis...
  • rsmith5413
    if I just leave the PWM line off. it works fine. but I have to bring in the UAV and manually pitch the
    gimbal with the on board switch...
Add a Comment