EN CN
Won't show Encoders
-
Not all encoders show up in the GUI.
I can only see the yaw which was also there before I connected the encoders. -
I guess I just needed to buy the license ;)
-
Correct, the free version of the firmware only allows for encoding of the yaw motor. For 2 or 3 axis encoder gimbals, you need to buy a license. There's also a free trial version of the licensed firmware that will allow you to at least try the configuration.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!