EN CN
Gimbal continuouslly turning
  • gows007
    I am using the 32bit Basecam Alexmos gimbal board. If I switch it on, the Gimbal is rotating all the 3 axis and not stopping at all. I waited for 2 hours if it will eventually stop, but no. Can anyone please let me know what might be the reson for this.

    The GUI also get disconnected after a short duration, hence not able to auto calibrate number of poles.

    Thank You.
  • Garug
    Disconnect any you stick and RC control you have and disable them from GUI. Perform the complete basic setup, That should fix it and when it is working add joystick etc.

    And of course make sure no i2c errors etc.
Add a Comment