i'm trying to setup our Infinity-MRS gimbal for 2 man and 1 man operation using two or one Frsky X9e.
Base operating is 2 man. One X9e for the pilot with X8R receiver running SBUS on copter and one for the cam operator using X6R SBUS receiver on gimbal. Sometimes 1 man operation is necessary so i bind both receiver to the pilot x9e sharing the same 16 virtual channels leaving me only 8 channels of control for the gimbal and the need to swap virtual channels on alexmos 32bit 2.50b3 via profile switch. No problem so far.
Now comes the problem: apparently only channels set on RC Tab are saved with profiles, but not channels stored in slots in Adj.Vars Tab.