EN CN
I feel so boned
  • Lensflight
    So, I have an original TRD SP Beholder, the smartphone 3 axis. It's a legit board (version 1.0)

    I swear I saved the factory profile but I can't find it anywhere and neither can finder. When I updated the firmware to fix an issue where the gimbal would roll when pitched up or down I lost my whole profile.

    Some stuff I remember (motor power settings, and that the roll should be inverted), but that's about it.

    What are my options? I emailed TRD to see if they could send me the factory profile but no response yet. If anyone has tips or can link me to a guide to help me completely rebuild the profile I would be so grateful.
  • Garug
    http://www.basecamelectronics.com/files/v3/SimpleBGC_32bit_manual_2_50_eng.pdf

    And perform the setup according it. Requires some reading and following carefully the instructions, but not too difficult.
Add a Comment