EN CN
new to brushless gimbals and mine just has a mind of its own please help
-
My gimbal just bounces around and tries to do a 360 spin. I am unsure what setting to use when connected to computer. I have some videos of this issue if it helps and of my current settings? hope somebody out there can help
-
Obviously there is something wrong , but impossible to tell from the description what.
Maybe problem with IMU, probably with settings. -
Can I upload videos on here to show settings and fault
-
I would return that. It does not look like a legitimate BaseCam board, is it?
And there is also some HW problem, bad serial data and tons of I2C errors.
-
Double check your IMU connections. If you have a multi meter test for continuity and if you crimp your own cables make sure they are going to the proper pin outs.
-
I don't know it was purchased from eBay. It said it would work with my SJ4000 camera. Connections are all fine. Just need to know what settings are required. Motor voltage etc
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!