EN CN
IMU´s doesnt work anymore
  • typetoys
    Hey, I use Basecam 32 Bit BGC Controller with 2 IMU´s, so far so good,
    but since today both IMU´s just light up short after starting the Gimbal System
    and after that the light goes out, so they are connected but dont work anymore.
    Is there am possibility of reseting these IMU´s or the Controller to get them to work again?

    best tyll
  • Garug
    Make sure your cables and connectors are ok. It is also possible that the IMU is broken. You can reset the IMU (same place where you calibrate it.) This resets just the calibration data, if nothing else helps, worth trying.
Add a Comment