Hi,

I was inspired by this article : http://www.instructables.com/id/Brushless-Gimbal-Balancing-Robot/
and so I bought a similar : board http://www.aliexpress.com/item/BGC-3-0-MOS-2-Axis-Brushless-Gimbal-Controller-PTZ-Controller-w-Built-in-6050-Sensor/32506595939.html
This board has 'Basecam Electronics' printed on it, but I don't know if it is genuine or a clone...

My questions :
* can I program this board using the Arduino IDE ? (When plugged in a USB port, the Arduino IDE 'sees' the virtual COM port)
* if not, can I program it using the SimpleBGC GUI ?
* is there any HW info explaining on which pins the motor drivers are connected ?
* is there any open source Arduino library to drive the BLDC motors ?

Thank you!