EN CN
Firmware version 0.53 b4
  • kimdt27
    Hi guys

    note sure if you can help me, but i would like to get the GUI and my gimbal connected. however, when trying to connect i get the error message "Error: GUI vs board version mismatch. Firmware version: 0.53 b4, GUI version: 2.56 b7. You should run matching GUI, or upgrade firmware".

    Could you tell me where i get a matching GUI or a firmware update?

    Regards Kim
  • plasticman81
    im trying to figure out the same problem. Seems nobody has an answer for it. I emailed tech support, as soon as i find something out, ill post it here and let you know.
  • Dood116
    Same issue here. Please let me know if a solution is found.
  • Garug
    Is that a 32 bit board, is that a legitimate board? If yes, I would try the emergency flash, see the users manual.
Add a Comment