Hello, i have a pilotfly gimbal with two problems:

1. after having a few broken wires to the sensor, I installed last firmware and gimbal working without problems only in one profile. If i try to change profiles gimbal go crazy. So i use with only one profile

2. one day ago i update the firmware because when i plug the battery i have blue and green led blinking and no move at all from the motors and then is working only when usb is pluged in, otherwise blue and green led blinking fast and the motors are off, when i try to switch them on is only a small move .

The board is fried or is a software isue? how can i test it?

Thank you very much, and excuse me for my poor English