Hi people

i have a tiny board PRO bought from here

https://aerialpixels.com/shop/gimbals/brushless-gimbal-controllers/alexmos-tiny-pro-32-bit-brushless-gimbal-controller/

i'm using S-bus channels to remote pitch and yaw
i need to drive some servos as well and i programmed some channels out of the board for that but i can't find the power connector for the servos as it is in the starndard size boards

what's the best way to get power from the board to activate servos?
should i get the power from the same connectors used for the s-bus receiver??

i'm using the PWM output option from the RC menu

thanks in advance

Augusto