EN CN
Some initial issues! Buzzing/Firmware!
  • Jay_Z
    I have been searching for some answers as I get started working with my gimbal controller.

    Previously, I went to update and it seemed as though my card was an 8 bit, although it appeared to be the 32 bit. In any event, it allowed me to update the 8 bit firmware, which I did to the latest.

    Now, when I go to connect, it says GUI/Board type mismatch. Is there a way to confirm which firmware version is on this now?

    Secondly, when I plug this into power, I get the loud buzz. I didn't see that this reflects an error - what does this mean? The LED indicator is solid. When I power it up, it doesn't go through the initial startup sequence either. Power is connected as well as my gyro, pitch and roll connections.

    Any suggestions for these? Thanks so much!
  • Jay_Z
    Looking again, it is definitely 8 bit. I know I upgraded the firmware to the 8 bit 2.40b7. Either way, I can't connect with that GUI now - or, any other 8 bit GUI.

    I was hoping that by connecting to the GUI, I could figure out the loud buzzer issue!

    Again, thanks for your assistance!!
Add a Comment