EN RU CN
32bit board with angled motor pins?
  • I currently have a 32bit V3 board that has motor pins that are angled 90° (2 facing up, and 1 facing down), in order to give cleatance for the plastic cover this gimbal uses. I now need to replace this board due to a dead RC_Roll signal pin, but need those angled motor pins. Stock boards come with the motor pins facing out, away from the board. Does anyone know where I can find a board with angled motor pins? Can I bend those pins myself without them snapping?
  • well if you buy a new board should come with a case you do not need to worry about this! only 8 bit boards come without headers i have them in stock 32bit boards come with case!
    http://brushlessgimbal.ca/BRUSHLESS-GIMBAL-PTZ/Control