EN RU CN
Com Port Settings
  • I loaded driver on Win 7 x64 system. Trying to connect to 8 bit board. GUI shows com port 1 as a selection. Choose that and click Connect. Says connecting but never does. What do the port settings have to be? Have been looking on Forum without luck or the manual. Purchased gimbal from www.turboace.com and tech support says they used version 2.2b2. That is the interface I'm using. On connecting to USB I get a solid red light followed by a blinking green light that also goes solid after a few seconds. The gimbal is randomly moving around as if from noise or too much feedback. Trying to connect GUI to see parameters. Any help appreciated.
    Julio
  • Follow up. Contacted by tech, suggested I try different cable. Apparently some USB micro cables are power only for charging devices not carrying data. This was the case with mine. I swapped cables and computer recognized board!
  • Follow up. Contacted by tech, suggested I try different cable. Apparently some USB micro cables are power only for charging devices not carrying data. This was the case with mine. I swapped cables and computer recognized board!