Hi there people. I've seen similiar threads here, but I didn't find any solid answers, so I'm starting a new one. I'm running an AlexMos 3-axis board with 2.35b firmware on a DYS Smart 3-Axis gimbal (the one for gopro). I've been using it for less than ten hours over the last few weeks, and encoutered an issue today.

I did two flights and everything went well. Hooked up another battery, and the camera didnt't position itself. The board is flashing green and red, and the motors get no power. Upon hooking the board to the gui I got a message that I2C sensor is not connected. As you can probably imagine, the sensor and the connector are still in place - like they were 30 seconds before.

Any ideas what can be causing the problem?