EN CN
Oh man...every update new problems....
  • oergybln
    I updated from 2.50 to 2.50b3. With my macbook all worked fine. some fine tuning again. I started the gimbal and GUI new and after this the GUI doesn't conect to the board!? What's happend now?????
  • Garug
    It has happened me sometimes that the GUI/Java gets broken, especially if disconnecting USB when connection is active.

    Re-starting Mac has helped me.
  • oergybln
    I restarted my mac! No change....!
  • Garug
    You could try pressing the button 10 times, it will set everything to factory defaults, so hopefully you have your settings saved.
  • oergybln
    ok i will try
  • Garug
    if that does not help, see the flash procedure on users manual.
  • oergybln
    doesn't work...

    "You could try pressing the button 10 times, it will set everything to factory defaults, so hopefully you have your settings saved."
  • Garug
    How about the flash procedure
  • oergybln
    Doesn't work with any version!!
  • Garug
    If nothing really works, not even the emergency flash operation, then the board is broken, bad usb cable or the GUI/serialports/Java etc. is not properly configured.

    Do you get any connection with GUI?
  • oergybln
    yes connection for flash works. if I flashed and broke the flashbridge I get a lound beep. the GUI conect but the FW version isn't shown.
  • oergybln
    Now it works with 2.43.9, after 4 hours of flashing!! Wow
Add a Comment