EN CN
firmware 2.50
-
hello. Following a false manipulation ( firmware 2.50 ) on a map 2 axis GLB V3.1 , I can not connect to the card via the GUI . impossible to pass on COM6 ! In addition, there is no jumper on the board for manual reset .
How to do?
regards from France -
2 axis GLB V3.1 is a Chinese counterfeit which based on 8-bit hacked firmware. Now you can throw out your board.
-
I think I 'll do so !
Thanx
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!