EN RU CN
Problems while flashing firmware
  • Hello

    I connect the board to my PC, then I start the SimpleBCG_GUI ... i flash the recovery (*.hex) file. After that, I unuplug the USB, remove the jumper and connect it again to the USB. Then I use again SimpleBCG_GUI to connect. I connect and it says version 0.00 - i make a Automatic update check and update to the latest version. That all works without any error. When the firmware has been flashed, i remove the board again from the usb and reattach it. After this, the red light is blinking fast. I tried flashing other versions etc,l but always the same result.

    any idea what i'm doing wrong?

    thanks