EN CN
Frame IMU not selectable
  • DutchAerial
    Hi,

    When I click on the 'Frame IMU' button the selection jumps back to Camera IMU.

    Checked:

    - A bridge has been made on the 'Camera IMU.
    - Frame IMU has no bridge.
    - Wiring is checked ok, red led is on, on bough IMUs.
    - Advanced Tab is activated on 'Below Yaw'
    - Various older firmware tested.

    Board: BasecamElectronics v3.02

    Any one who can help me?
  • DutchAerial
    Solution found: Hidden connection in board between ADDR solder points.

    Needed to cut with a knife. Easy solution but it would be time saving if there where instructions provided ;)
Add a Comment