EN CN
DJI Lightbridge - Control Basecam Gimbal
  • Steven2728
    Hi All,

    I have a Vulcan X8 Z Arms with a BaseCam 32bit control board for the gimbal.

    I'm wondering if its possible to link the DJI lightbridge gimbal output to operate the basecam gimbal (its designed for the DJI Zemuse gimbal)

    I have if needed a DJI Zemuse GCU unit but not the gimbal, is it possible to run the gimbal via the lightbridge gimbal port?

    Thanks
    Sp
  • Garug
    I do not have light bridge, but is it not providing DBUS out. On Naza that means same as Futaba SBUS, so it should be possible to connect that to the BaseCam board.

    Note: If you use that also for controlling the multicopter, I think someone mentioned earlier that a active signal splitter is needed.

    DJI never makes it easy to connect any 3rd party stuff, but it is possible...
Add a Comment