EN CN
Help: How to program a JR11X radio for 32bit version
-
I have a JR11X radio and the 32bit board. I'm using a two receiver setup. Bound two receivers to single radio to accommodate Blade 350 QX3 using first few channels for control. I'm using channels above 5 for gimbal on the second receiver.
How best to program radio so I get modes and Yaw, Tilt control. -
Does that radio have sliders or potentiometers? If you are using the sticks for controlling the airgraft, you would need sliders/potentiometer for controlling the yaw and tilt.
Yaw you can also set to follow mode.
If you do not have sliders, you can still use the switches for some raw control of pitch and yaw (but not really useful) and you ca use them for selecting mode etc. up to you what you want to do. -
Yes there are two sliders. I have managed to get yaw and tilt on those sliders but I can't figure out how get get modes working. What is the best way to do that?
You are also correct. Main controls are for controlling the quad. -
Easiest way to do that is assign a channel for CMD and then assign the commands up to 3 of them, RC tab.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!