EN CN
panne
-
led rouge fixe
après branché usb verte clignote 3 fois stop 3 fois stop 3 fois et plus rien
pas de message sur écran
pas de lecture du firmware , ?
pas de détection, pas de message " imu non branché"
une idée géniale ??? -
Hello, Please write your question in English. Thank you.
-
je vais le faire, mais vous savez, quand vous écrivez, je passes par google traduction.........
I'll do it, but you know, when you write, I pass by google translation ......... -
the card works on my first gimbal
I mounted on my 2em gimbal, without changing anything, so it is set
including wiring
I put on, the red LED lights fixed
and nothing else happens
I open the software
I connect USB
the green LED flashes 3 times quickly, 1 stop, it flashes 3 times again, it stops, it flashes again 3 times and then stops permanently
the red LED remains constantly on
on the software, I see that she does not read the firmware that is on the map
and therefore nothing happens, and nothing works, not a single engine moves and not a single message software
an idea ..... -
thank you for giving me an idea of what kind of failure
-
Hello, Please, send us photos of both sides of your board in high resolution.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!