EN CN
Axis control without gyro/acceleration sensor input
  • mar344
    Hi
    I am new to the forum and relatively new to the AlexMos/Basecam project.
    For the usage on small crane, I will build a gimbal in order to control two axis. Mostly, we need no stabilization of the axes on the crane. Is there a way to disable the stabilization (gyro/acceleration sensor ) so that the movement of the axes only is driven by the RC signal?

    Thanks for support.

    Kind regards
    martin
  • alexmosalexmos
    Hi,
    No, its not possible. Brushless motors need a feedback to control. For your target better to use steppers and dedicated controller for them.
  • mar344
    Thank you Alex
Add a Comment