EN CN
I need of some guidance!!
  • DDFilms
    Ok so I want to assemble my own brushless gimbal for my Blackmagic Cinema Camera. Can anybody make any suggestions on what Frames,motors,controllers, etc. to look in too as well as any schematics to help me during the assembling process. Also keeping it with thin a budget? I am aware that I am going to spend more than $1000 on this. Any input would be greatly appreciated.

    Cheers
    Adan
  • HighImages
    Adan,

    Be prepared for quite a bit of trouble shooting, frustration and finally hopefully excitement.

    I am not sure how far along you are into you research but there is another forum that gives quite a bit more information about general hand held gimbals.

    http://www.rcgroups.com/forums/showthread.php?t=2123657

    This forum has a lot of specific troubleshooting information but not tons of general gimbal info.

    Hope this at least gets you started in the right direction!

    Tom
  • AOPEN3434AOPEN3434
    Not in to the DYI or you not very technical don't find troubleshooting fun ? Well decided to introduce a ready to use hand held gimbal with copter landing gear combo so you can use on professional copter like Cinestar , S1000 , S800 , Droid works , carbon core, torat or hand held .
    We kidding about the not being technical you still need to balance camera and configure the BGC software but that's it no tools required. here is the URL for Gimbal only

    http://brushlessgimbal.ca/index.php?main_page=product_info&cPath=20_22&products_id=983

    combo hand held & copter

    http://brushlessgimbal.ca/index.php?main_page=product_info&cPath=20_22&products_id=984
Add a Comment