"Failed to upload: Error writing firmware: [1] Unable to connect to bootloader"
Background: Board not responsive, so it was manually flashed according to the instructions on this site and the manual. Details: Using OS X. Firmware and GUI on 2.42 b7 32 bit board.
Obviously the manual flash didn't work, but I haven't seen this particular error, and I'm curious if it points to a solution.
Hi there, I wanted to Close (set) FLASH jumper on board, but I couldnt find this jumper. Can anyone tell me where to find it? There is nothing written on it except that the board is a Basecam product. I assume it's a 32Bit board and I might have upgraded the firmware to 8Bit by accident... now power LED is on and the blue LED blinks a few times and then stays off. That's why I wanted to do a recovery. ps: thanks for helping a rookie!