Is it only me or are there others with the following problems? (Flyduino 32bit board, Firmware 2.42b7)
1. If I activate Follow Mode on Pitch/Roll and the Roll Motor misses steps accidently, Roll doesn't come back to the initial angle. If I deactivate Follow Mode on pitch/Roll, it does / everything is fine. (was the same in Firmware vers. 2.242b7
Wouldn't it be possible to enable "Follow Pitch" and "Follow Roll" independently on the FollowMode-Tab of the GUI? (I never use Follow Mode on Roll but I really need Roll to come back to the perfect / init angle after any disturbance / bump / missed steps...)
2. GUI Vers. 2.242b7 seems to be strange, BatteryInfo on Service Page ist greyed out / inactive and Firmware Upgrade Page is missing the "check" button and so on...? Smething missing in the new GUI?