EN CN
Yaw "follow me" not following.
  • glmccready
    I've got my 32-bit fairly tuned in, but having trouble with the "Follow me" on the YAW. It starts out straight ahead when I lift off, but as I yaw my copter it sometimes lags and then is pointing at a leg. It doesn't go more to one side than the other. I then just hover and use my Transmitter dial to move it back to center. I tried putting in physical stops on my 8-bit, but it would setup a jello, that the gimbal would not recover from. (haven't tried that with this gimbal yet)
    Someone else with this problem attaching a joystick type potentiometer to the YAW, and said that worked.
    Is there some setting I'm missing. There seems to be plenty of power.
    FYI: RCTimer Legacy with a Canon t2i. Latest firmware.
    http://youtu.be/cbvEvI0MI4s?list=UUdQnaka4W92qiMPXByzze7g
  • Peterev
    Same here.. It seems to be an issue with the 32 bit controller or 2.42 firmware. I've swapped out the 8 bit board for the 32 bit board on a DYS 3 axis gimbal and the same thing happens with mine. I almost wish I'd saved myself the £120 buying this until issues like this are resolved.

    Does anybody know if there's a fix on the way or are we stuck with this issue that makes the gimbal almost unusable?
  • Peterev
    http://youtu.be/fvxszkZfP8Q
  • Peterev
    Well I re-calibrated the IMUs using a bubble level and it's made a vast difference so my apologies to Basecam for doubting them..

    http://youtu.be/n3yt9tbj8vk
Add a Comment