EN RU CN
Auto PID Tune won't start
  • Hello, I have two 32 bit 3 axis BGC controllers with identical set ups. One of the controllers auto PID tunded beautifully, however the other one will not start the process. I can change the PID values manually. When I click Auto - tick roll - tick start from Zero and then click start nothing happens. The PID numbers do not change. Any idea?
  • Sounds really strange, maybe erase EEPROM and copying the settings from the other board would help.
  • This happening to me as well.
    I tried the EEPROM erase and still nothing.
  • seen this happen if the sensor orientation is incorrect or sensor not calibrated .
  • same prob here, sensors are OK. It just wont start
  • same here, it doesnt start. The board works well otherwise.