Since I purchased the system in January , I have been fighting, I do mean fighting, to get it to function. Had a problem with the original 16bit, and was convinced to upgrade to the 32 bit version. Had it tuned great in the shop in May... went out to fly... The gimbal went completely berserk!! I was so frustrated, I shelved it until a couple weeks ago. Re balanced checked out in the shop, flew not too bad, but cannot stop it from rolling while panning!! Tried some changes, no luck... returned to settings that were fine .... going berserk again!!!!!
If anyone has figured out how to set it so it does not need a major tune up every time it is used.... Pleas tell me how
So far this is the most expensive piece of garbage I have purchsed